Gaussian,non-Gaussian critical fluctuations in the Curie-Weiss model

It is known that at the critical temperature the Curie-Weiss mean-field model has non-Gaussian fluctuations and that internal fluctuations can be Gaussian. Here we compute the distribution of theq-mode magnetization fluctuations as a function of the temperature, the wave vectorq, and a fading out external field. We obtain new classes of probability distributions generated by this external field as well as new critical behavior in terms of its rate of fading out. We discuss also the susceptibility as the limitq tending to zero.     

Cluster description of water-in-oil microemulsions near the critical and percolation points

The three-component ionic microemulsion system consisting of AOT/water/decane shows an unusual phase behavior in the vicinity of room temperature. The phase diagram in the temperature-volume fraction (of the dispersed phase) plane exhibits a lower consolute critical point at about 40 degrees centigrades and 10% volume fraction. A percolation line, starting from the vicinity of the critical point, cuts across the plane, extending to high volume fraction side at progressively lower temperatures. In this paper we review the evidence that allows to interpret the phase behavior of our system in terms of interacting spherical droplets. We also investigate the dynamics of droplets, below and approaching the critical point by dynamic light scattering. The first cumulant and time evolution of the droplet density correlation function can be quantitatively calculated by assuming the existence of polydispersed fractal clusters formed by the microemulsion droplets due to attraction. The relaxation phenomena observed in an extensive set of measurements of electrical conductivity and permittivity close to percolation is also reviewed and interpreted through the same cluster-forming mechanism, which reproduces the most relevant features of the frequency-dependent complex dielectric constant of this system. Paper presented at the I International Conference on Scaling Concepts and Complex Fluids, Copanello, Italy, July 4–8, 1994.     

On retroactive occurrence and twin events in quantum mechanics

Bohr's well-known claim that only a registered phenomenon is a true phenomenon is further elaborated into occurrence in the past: If ideal occurrence of an eventP ((1–P)) is a state at a timet _i makes another eventQ ((1–Q))certain at a later timet _f, and, finallyU is the evolution operator fromt _i tot _f, then, it is proved that the final collapsed stateQ(U U ⁺)Q/TrQU U ⁺, which comes about in ideal occurrence ofQ att _f,equals the initial collapsed stateU(P P/TrP)U ⁺, which evolves from the state resulting from the ideal occurrence ofP in att _i. Utilizing the latter state is called theretroactive apparent ideal occurrence (RAIO) ofP in. A number of consequences, including the general notion of twin events (the case whent _f=t _i, andU=1) is derived. It is pointed out that RAIO is relevant in second-kind quantum measurement, in Wheeler's delayed-choice experiments in second-kind (or conditional) quantum preparators.     

Subtleties in data analysis related to the size of critical region

We comment on the analysis of the critical behavior of a layered driven diffusive system recently done by Achahbar and Marro. We discuss why we believe their method of taking the thermodynamic limit and determining the order-parameter exponent leads to unreliable estimates.     

Thermoreversible gelation of polyacrylonitrile/dimethylformamide-solution

The thermoreversible gelation of semi-diluted atactic polyacrylnitrile (PAN)/dimethylformamide (DMF)-solutions has been studied. The structural features of PAN/DMF-gels, formed by supercooling have been investigated by DSC-, x-ray- and swelling measurements. A new structural model has been introduced to describe the morphology of the junction zones of PAN/DMF-gels and to also explain the gelation behavior of PAN/DMF-solutions as the structural features of PAN/DMF-gels. The junction zones of a PAN/DMF-gel have been defined as ordered junction zones.A gelation enthalpy of about H=–6 kJ/mol supports the idea that an ordered junction zone is formed by intermolecularly neighboring stereoregular parts of atactic PAN chains due to a nucleation process in the solution. It can be defined as a strongly distributed fringed micelle.     

Study of the three-dimensional Ising model on film geometry with the cluster Monte Carlo method

Topological properties of clusters are used to extract critical parameters. This method is tested for the bulk properties ofd=2 percolation and thed=2, 3 Ising model. For the latter we obtain an accurate value of the critical temperatureJ/k _B T _c=0.221617(18). In the case of thed=3 Ising model with film geometry the critical value of the surface coupling at the special transitions is determined as J_1c/J=1.5004(20) together with the critical exponents ₁ ^m =0.237(5) and=0.461(15).     

Modifying the thermosensitivity of copolymers of sodium styrene sulfonate and<Emphasis Type="Italic"> N</Emphasis>-isopropylacrylamide with dodecyltrimethylammonium chloride

The interactions between copolymers of sodium styrene sulfonate (SSS) and N-isopropylacrylamide (NIPAM), anionic polyelectrolytes, and dodecyltrimethylammonium chloride (DTAC), a cationic surfactant, were studied in aqueous solutions of various ionic strengths. The copolymers were found to be thermoresponsive, showing a lower critical solution temperature (LCST). The influence of the polymer composition, the surfactant concentration, and the ionic strength on the LCST was studied. The surfactant was found to interact strongly with the polymer, forming mixed polymer-surfactant micelles. The critical aggregation concentration (cac) of the polymer-surfactant system was found from fluorescence spectroscopy using pyrene as a fluorescent probe. A strong dependence of the anionic polyelectrolyte-cationic surfactant interactions on the structure of the ionic comonomer was observed.     

Finite-size scaling and the renormalization group

Renormalization group calculations ind = 4 andd = 4 – are performed for a system of finite size. A form of mean-field theory is used which yields a rounded transition for a finite system, and this allows a sensible expansion in fluctuations. A combination of Ewald and Poisson sum techniques is used to produce explicit numerical results for the specific heat ind = 4 which, with the setting of two nonuniversal metrical factors and the fourth-order coupling constant may be compared with simulations. The numerical visibility of logarithmic corrections is investigated. The universal scaling function for the specific heat to relativeO() is also evaluated numerically.     

New Monte Carlo method for the self-avoiding walk

We introduce a new Monte Carlo algorithm for the self-avoiding walk (SAW), and show that it is particularly efficient in the critical region (long chains). We also introduce new and more efficient statistical techniques. We employ these methods to extract numerical estimates for the critical parameters of the SAW on the square lattice. We find=2.63820 ± 0.00004 ± 0.00030=1.352 ± 0.006 ± 0.025v=0.7590 ± 0.0062 ± 0.0042 where the first error bar represents systematic error due to corrections to scaling (subjective 95% confidence limits) and the second bar represents statistical error (classical 95% confidence limits). These results are based on SAWs of average length 166, using 340 hours CPU time on a CDC Cyber 170–730. We compare our results to previous work and indicate some directions for future research.     

Ward's identity in critical dynamics

We consider the relaxation of an order-parameter fluctuation of wave numberk in a system undergoing a second-order phase transition. In general, close to the critical point, wherek ^{–1 –1} (the correlation length) the relaxation rate has a linear dependence on/k of the form (k, ) = (k, 0)x(1–a/k). In analogy with the use of Ward's identity in elementary particle physics, we show that the numerical coefficienta is readily calculated by means of a mass insertion. We demonstrate, furthermore, that this initial linear drop is the main feature of the full/k dependence of the scaling functionR ^–x (k,), wherex is the dynamic critical exponent andR=(k²+ ²)^1/2 is the distance variable.